]]>
Je me suis dit, je vais regarder avec .... iwconfig et iwlist sccan :
J'ai cru que ma connexion était désactivé mais là surprise, j'ai l'impression que j'y ai aps accès en fait car si je tape ip link set wlan0 up :
j'obtiens
Ca vous parait pas bizarre ?]]>
T'indiquera si wicd est installé.
Pareil pour network-manager.
Leu tuto :
https://debian-facile.org/doc:systeme:apt:apt-cache]]>
la ligne non commentée psk= est ta clé chiffrée, c'est celle là que tu dois mettre après wpa-psk dans ton fichier interfaces]]>
]]>
Si tu vois tes réseaux c'est une histoire de config...
auto wlan0 #change this to the name of your WiFi interface
iface wlan0 inet dhcp #this is normally fine, if you want a static IP address replace “dhcp” with “static”
netmask 255.255.255.0 #change this as appropriate for your network, this value is usually right
gateway 192.168.1.1 #change this as appropriate for your network
address 192.168.1.100 #only needed for a static IP address
dns-nameservers 192.168.1.1 #only needed for a static IP address
wpa-driver wext #you shouldn’t need to change this
wpa-ssid YOURSSID #just type the name of your SSID here
wpa-ap-scan 1 #if the name of your SSID is hidden usually, type 2 instead of 1
wpa-proto WPA #if you use WPA1 type WPA, if you use WPA2 type RSN
wpa-pairwise CCMP #if you use AES type CCMP, if you use TKIP type TKIP
wpa-group CCMP #if you use AES type CCMP, if you use TKIP type TKIP
wpa-key-mgmt WPA-PSK #usually WPA-PSK (if you share a key) but sometimes WPA-EAP (for enterprises)
wpa-psk YOURHEXKEYFROMABOVE #the hex key that you generated earlier]]>
]]>