$ cat /etc/default/hdparm
# To set the same options for a block of harddisks, do so with something
# like the following example options:
# harddisks="/dev/hda /dev/hdb"
# hdparm_opts="-d1 -X66"
# This is run before the configuration in hdparm.conf. Do not use
# this arrangement if you need modules loaded for your hard disks,
# or need udev to create the nodes, or have some other local quirk
# These are better addressed with the options in /etc/hdparm.conf
#
harddisks="/dev/sda"
hdparm_opts="-B 254"
# By default, hdparm will refuse to set harddisk options on any drive
# if the system has software RAID running, and one or more disk arrays
# are in the process of resynchronisation.
# With this variable set to 'yes', /etc/init.d/hdparm will suspend the
# RAID resynchronisation process before setting harddisk options, and
# will resume it after setting is done.
RAID_WORKAROUND=no