j'ai encore un doute mais sur un SSD cette fois (c'est ma partition / et /home):
smartctl --all /dev/sdd
smartctl 6.4 2014-10-07 r4002 [x86_64-linux-3.16.0-4-amd64] (local build)
Copyright (C) 2002-14, Bruce Allen, Christian Franke, www.smartmontools.org
=== START OF INFORMATION SECTION ===
Model Family: SandForce Driven SSDs
Device Model: FM-25S2S-60GBP2
Serial Number: GS06103107280002
LU WWN Device Id: 5 000000 107280002
Firmware Version: 3.1
User Capacity: 60 022 480 896 bytes [60,0 GB]
Sector Size: 512 bytes logical/physical
Rotation Rate: Solid State Device
Device is: In smartctl database [for details use: -P show]
ATA Version is: ATA8-ACS T13/1699-D revision 6
SATA Version is: SATA 2.6, 3.0 Gb/s
Local Time is: Tue Mar 24 08:45:58 2015 CET
SMART support is: Available - device has SMART capability.
SMART support is: Enabled
=== START OF READ SMART DATA SECTION ===
SMART overall-health self-assessment test result: PASSED
General SMART Values:
Offline data collection status: (0x00) Offline data collection activity
was never started.
Auto Offline Data Collection: Disabled.
Self-test execution status: ( 0) The previous self-test routine completed
without error or no self-test has ever
been run.
Total time to complete Offline
data collection: ( 0) seconds.
Offline data collection
capabilities: (0x7f) SMART execute Offline immediate.
Auto Offline data collection on/off support.
Abort Offline collection upon new
command.
Offline surface scan supported.
Self-test supported.
Conveyance Self-test supported.
Selective Self-test supported.
SMART capabilities: (0x0003) Saves SMART data before entering
power-saving mode.
Supports SMART auto save timer.
Error logging capability: (0x01) Error logging supported.
General Purpose Logging supported.
Short self-test routine
recommended polling time: ( 1) minutes.
Extended self-test routine
recommended polling time: ( 48) minutes.
Conveyance self-test routine
recommended polling time: ( 2) minutes.
SCT capabilities: (0x003d) SCT Status supported.
SCT Error Recovery Control supported.
SCT Feature Control supported.
SCT Data Table supported.
SMART Attributes Data Structure revision number: 10
Vendor Specific SMART Attributes with Thresholds:
ID# ATTRIBUTE_NAME FLAG VALUE WORST THRESH TYPE UPDATED WHEN_FAILED RAW_VALUE
1 Raw_Read_Error_Rate 0x000f 099 099 050 Pre-fail Always - 0/2626522
5 Retired_Block_Count 0x0033 100 100 003 Pre-fail Always - 0
9 Power_On_Hours_and_Msec 0x0032 100 100 000 Old_age Always - 17367h+06m+30.850s
12 Power_Cycle_Count 0x0032 098 098 000 Old_age Always - 2165
171 Program_Fail_Count 0x0032 000 000 000 Old_age Always - 0
172 Erase_Fail_Count 0x0032 000 000 000 Old_age Always - 0
174 Unexpect_Power_Loss_Ct 0x0030 000 000 000 Old_age Offline - 95
177 Wear_Range_Delta 0x0000 000 000 --- Old_age Offline - 1
181 Program_Fail_Count 0x0032 000 000 000 Old_age Always - 0
182 Erase_Fail_Count 0x0032 000 000 000 Old_age Always - 0
187 Reported_Uncorrect 0x0032 100 100 000 Old_age Always - 0
194 Temperature_Celsius 0x0022 001 000 000 Old_age Always - 1
195 ECC_Uncorr_Error_Count 0x001c 099 099 000 Old_age Offline - 0/2626522
196 Reallocated_Event_Count 0x0033 100 100 003 Pre-fail Always - 0
231 SSD_Life_Left 0x0013 100 100 010 Pre-fail Always - 0
233 SandForce_Internal 0x0000 000 000 000 Old_age Offline - 6272
234 SandForce_Internal 0x0032 000 000 000 Old_age Always - 3136
241 Lifetime_Writes_GiB 0x0032 000 000 000 Old_age Always - 3136
242 Lifetime_Reads_GiB 0x0032 000 000 000 Old_age Always - 9536
SMART Error Log not supported
SMART Self-test Log not supported
SMART Selective self-test log data structure revision number 1
SPAN MIN_LBA MAX_LBA CURRENT_TEST_STATUS
1 0 0 Not_testing
2 0 0 Not_testing
3 0 0 Not_testing
4 0 0 Not_testing
5 0 0 Not_testing
Selective self-test flags (0x0):
After scanning selected spans, do NOT read-scan remainder of disk.
If Selective self-test is pending on power-up, resume after 0 minute delay.
cat /var/log/daemon.log
...
Mar 23 17:37:15 PC343B smartd[864]: Device: /dev/sdd [SAT], SMART Prefailure Attribute: 1 Raw_Read_Error_Rate changed from 120 to 99
Mar 23 17:37:15 PC343B smartd[864]: Device: /dev/sdd [SAT], SMART Usage Attribute: 195 ECC_Uncorr_Error_Count changed from 120 to 99
M
Mar 23 18:07:15 PC343B smartd[864]: Device: /dev/sdd [SAT], SMART Prefailure Attribute: 1 Raw_Read_Error_Rate changed from 99 to 100
Mar 23 18:07:15 PC343B smartd[864]: Device: /dev/sdd [SAT], SMART Usage Attribute: 195 ECC_Uncorr_Error_Count changed from 99 to 100
M
Mar 23 20:37:14 PC343B smartd[864]: Device: /dev/sdd [SAT], SMART Prefailure Attribute: 1 Raw_Read_Error_Rate changed from 100 to 102
Mar 23 20:37:14 PC343B smartd[864]: Device: /dev/sdd [SAT], SMART Usage Attribute: 195 ECC_Uncorr_Error_Count changed from 100 to 102
Ma
Mar 24 08:11:46 PC343B smartd[865]: Device: /dev/sdd, type changed from 'scsi' to 'sat'
Mar 24 08:11:46 PC343B smartd[865]: Device: /dev/sdd [SAT], FM-25S2S-60GBP2, S/N:GS06103107280002, WWN:5-000000-107280002, FW:3.1, 60.0 GB
Mar 24 08:11:46 PC343B smartd[865]: Device: /dev/sdd [SAT], found in smartd database: SandForce Driven SSDs
Mar 24 08:11:46 PC343B smartd[865]: Device: /dev/sdd [SAT], can't monitor Current_Pending_Sector count - no Attribute 197
Mar 24 08:11:46 PC343B colord: loaded plugin libcd_plugin_scanner.so
Mar 24 08:11:46 PC343B smartd[865]: Device: /dev/sdd [SAT], no SMART Self-test Log, ignoring -l selftest (override with -T permissive)
Mar 24 08:11:46 PC343B smartd[865]: Device: /dev/sdd [SAT], no SMART Error Log, ignoring -l error (override with -T permissive)
Mar 24 08:11:46 PC343B smartd[865]: Device: /dev/sdd [SAT], is SMART capable. Adding to "monitor" list.
...