Bonjour
J'ai un soucis avec mes 2 clé USB de stockage elle se mettent en erreur et freeze le curseur de ma souris puis la souris devient inactive a son tour
Je débranche la clé et replug la souris pour que celle si fonctionne
seule solution que j'ai trouvé qui fonctionne est de retiré le module ehci-pci
De ce fait la clé USB fonctionne avec le module ohci-pci
Je ne met volontairement que ce qui concerne les ports USB
00:03.0 USB controller: Silicon Integrated Systems [SiS] USB 1.1 Controller (rev 0f)
Subsystem: ASRock Incorporation USB 1.1 Controller
Kernel driver in use: ohci-pci
Kernel modules: ohci_pci
00:03.1 USB controller: Silicon Integrated Systems [SiS] USB 1.1 Controller (rev 0f)
Subsystem: ASRock Incorporation USB 1.1 Controller
Kernel driver in use: ohci-pci
Kernel modules: ohci_pci
00:03.2 USB controller: Silicon Integrated Systems [SiS] USB 2.0 Controller
Subsystem: ASRock Incorporation USB 2.0 Controller
Kernel driver in use: ehci-pci
Kernel modules: ehci_pci
Juste la souris de branché
/: Bus 03.Port 1: Dev 1, Class=root_hub, Driver=ohci-pci/3p, 12M
/: Bus 02.Port 1: Dev 1, Class=root_hub, Driver=ohci-pci/3p, 12M
|__ Port 1: Dev 2, If 0, Class=Human Interface Device, Driver=usbhid, 1.5M
/: Bus 01.Port 1: Dev 1, Class=root_hub, Driver=ehci-pci/6p, 480M
Quand je branche la clé USB elle est bien reconnu et utilise ehci-pci pendant un cours instant
tail -f /var/log/kern.log
Apr 26 14:54:26 handylinux kernel: [ 1330.082922] [UFW BLOCK] IN=eth0 OUT= MAC=01:00:5e:00:00:01:00:23:48:c3:9e:c0:08:00 SRC=192.168.1.1 DST=224.0.0.1 LEN=32 TOS=0x00 PREC=0x80 TTL=1 ID=0 DF PROTO=2
Apr 26 14:54:59 handylinux kernel: [ 1363.300023] usb 1-2: new high-speed USB device number 3 using ehci-pci
Apr 26 14:54:59 handylinux kernel: [ 1363.449876] usb 1-2: New USB device found, idVendor=18a5, idProduct=0245
Apr 26 14:54:59 handylinux kernel: [ 1363.449882] usb 1-2: New USB device strings: Mfr=1, Product=2, SerialNumber=3
Apr 26 14:54:59 handylinux kernel: [ 1363.449884] usb 1-2: Product: STORE N GO
Apr 26 14:54:59 handylinux kernel: [ 1363.449886] usb 1-2: Manufacturer: Verbatim
Apr 26 14:54:59 handylinux kernel: [ 1363.449888] usb 1-2: SerialNumber: 14101859001587
Apr 26 14:54:59 handylinux kernel: [ 1363.551244] usb-storage 1-2:1.0: USB Mass Storage device detected
Apr 26 14:54:59 handylinux kernel: [ 1363.554072] scsi host2: usb-storage 1-2:1.0
Apr 26 14:54:59 handylinux kernel: [ 1363.554325] usbcore: registered new interface driver usb-storage
Apr 26 14:54:59 handylinux kernel: [ 1363.566734] usbcore: registered new interface driver uas
Apr 26 14:55:00 handylinux kernel: [ 1364.812046] usb 2-1: reset low-speed USB device number 2 using ohci-pci
Apr 26 14:55:01 handylinux kernel: [ 1365.144031] usb 2-1: device descriptor read/64, error -62
Apr 26 14:55:01 handylinux kernel: [ 1365.193904] scsi 2:0:0:0: Direct-Access Verbatim STORE N GO PQ: 0 ANSI: 4
Apr 26 14:55:01 handylinux kernel: [ 1365.197410] sd 2:0:0:0: Attached scsi generic sg3 type 0
Apr 26 14:55:01 handylinux kernel: [ 1365.198079] sd 2:0:0:0: [sdc] 15482880 512-byte logical blocks: (7.93 GB/7.38 GiB)
Apr 26 14:55:01 handylinux kernel: [ 1365.198829] sd 2:0:0:0: [sdc] Write Protect is off
Apr 26 14:55:01 handylinux kernel: [ 1365.198835] sd 2:0:0:0: [sdc] Mode Sense: 43 00 00 00
Apr 26 14:55:01 handylinux kernel: [ 1365.199587] sd 2:0:0:0: [sdc] No Caching mode page found
Apr 26 14:55:01 handylinux kernel: [ 1365.199598] sd 2:0:0:0: [sdc] Assuming drive cache: write through
Apr 26 14:55:01 handylinux kernel: [ 1365.208100] sdc: sdc1
Apr 26 14:55:01 handylinux kernel: [ 1365.211403] sd 2:0:0:0: [sdc] Attached SCSI removable disk
Apr 26 14:55:01 handylinux kernel: [ 1365.584081] usb 2-1: device descriptor read/64, error -62
Apr 26 14:55:01 handylinux kernel: [ 1366.020027] usb 2-1: reset low-speed USB device number 2 using ohci-pci
Apr 26 14:55:02 handylinux kernel: [ 1366.352027] usb 2-1: device descriptor read/64, error -62
Apr 26 14:55:03 handylinux kernel: [ 1367.204032] usb 2-1: device not accepting address 2, error -62
Apr 26 14:55:03 handylinux kernel: [ 1367.536028] usb 2-1: reset low-speed USB device number 2 using ohci-pci
Apr 26 14:55:03 handylinux kernel: [ 1367.952029] usb 2-1: device not accepting address 2, error -62
Apr 26 14:55:04 handylinux kernel: [ 1368.280028] usb 2-1: reset low-speed USB device number 2 using ohci-pci
Apr 26 14:55:04 handylinux kernel: [ 1368.696030] usb 2-1: device not accepting address 2, error -62
Apr 26 14:55:04 handylinux kernel: [ 1368.696229] usb 2-1: USB disconnect, device number 2
Apr 26 14:55:04 handylinux kernel: [ 1368.876031] usb 2-1: new low-speed USB device number 3 using ohci-pci
Apr 26 14:55:05 handylinux kernel: [ 1369.060079] usb 2-1: device descriptor read/64, error -62
Apr 26 14:55:05 handylinux kernel: [ 1369.352026] usb 2-1: device descriptor read/64, error -62
Apr 26 14:55:05 handylinux kernel: [ 1369.640028] usb 2-1: new low-speed USB device number 4 using ohci-pci
Apr 26 14:55:05 handylinux kernel: [ 1369.824097] usb 2-1: device descriptor read/64, error -62
Apr 26 14:55:06 handylinux kernel: [ 1370.101863] [UFW BLOCK] IN=eth0 OUT= MAC=01:00:5e:00:00:01:00:23:48:c3:9e:c0:08:00 SRC=192.168.1.1 DST=224.0.0.1 LEN=32 TOS=0x00 PREC=0x80 TTL=1 ID=0 DF PROTO=2
Apr 26 14:55:06 handylinux kernel: [ 1370.103624] [UFW BLOCK] IN=eth0 OUT= MAC=01:00:5e:00:00:01:00:23:48:c3:9e:c0:08:00 SRC=192.168.1.1 DST=224.0.0.1 LEN=32 TOS=0x00 PREC=0x80 TTL=1 ID=0 DF PROTO=2
Apr 26 14:55:06 handylinux kernel: [ 1370.116233] usb 2-1: device descriptor read/64, error -62
Apr 26 14:55:06 handylinux kernel: [ 1370.224067] usb usb2-port1: attempt power cycle
Apr 26 14:55:06 handylinux kernel: [ 1370.720051] usb 2-1: new low-speed USB device number 5 using ohci-pci
Apr 26 14:55:07 handylinux kernel: [ 1371.136028] usb 2-1: device not accepting address 5, error -62
Apr 26 14:55:07 handylinux kernel: [ 1371.316062] usb 2-1: new low-speed USB device number 6 using ohci-pci
Apr 26 14:55:07 handylinux kernel: [ 1371.732029] usb 2-1: device not accepting address 6, error -62
Apr 26 14:55:07 handylinux kernel: [ 1371.732081] usb usb2-port1: unable to enumerate USB device
J'ai a peu prés tout essayé d’après ce que j'ai pu trouver sur le net
Changement de parametres sur le module usbcore et ehci
Tentative de vidage des condensateurs
Je mettais résolu a blacklister le module ehci-pci pour de bon mais aucune méthode ne semble fonctionner
Dernière modification par Croutons (26-04-2018 19:48:36)
-->les cahiers du debutant<-- WikiDF-->Découvrir les principales commandes Linux<--
L' expérience, c'est le nom que chacun donne à ses erreurs. Oscar Wilde