raleur a écrit :Le paquet firmware-atheros ne contient pas de pilote mais des firmwares...
Oui, oups... merci pour ta réponse. Installation de Debian 11 toute fraîche de ce matin.
Voici ce qui sort :
[ 6.438502] cfg80211: Loaded X.509 cert 'romain.perier@gmail.com: 3abbc6ec146e09d1b6016ab9d6cf71dd233f0328'
[ 6.438775] cfg80211: Loaded X.509 cert 'sforshee: 00b28ddf47aef9cea7'
[ 6.441446] platform regulatory.0: firmware: direct-loading firmware regulatory.db
[ 6.442040] platform regulatory.0: firmware: direct-loading firmware regulatory.db.p7s
[ 6.680230] usb 2-1.2: ath9k_htc: Firmware ath9k_htc/htc_9271-1.4.0.fw requested
[ 6.680262] usbcore: registered new interface driver ath9k_htc
[ 6.680469] usb 2-1.2: firmware: failed to load ath9k_htc/htc_9271-1.4.0.fw (-2)
[ 6.680472] firmware_class: See https://wiki.debian.org/Firmware for information about missing firmware
[ 6.680475] usb 2-1.2: Direct firmware load for ath9k_htc/htc_9271-1.4.0.fw failed with error -2
[ 6.680479] usb 2-1.2: ath9k_htc: Firmware htc_9271.fw requested
[ 6.680492] usb 2-1.2: firmware: failed to load htc_9271.fw (-2)
[ 6.680495] usb 2-1.2: Direct firmware load for htc_9271.fw failed with error -2
[ 6.680497] usb 2-1.2: no suitable firmware found!
[ 6.680615] usb 2-1.2: ath9k_htc: USB layer deinitialized
[ 6.711146] kvm: VM_EXIT_LOAD_IA32_PERF_GLOBAL_CTRL does not work properly. Using workaround
[ 6.792644] snd_hda_codec_via hdaudioC0D0: autoconfig for VT2020: line_outs=4 (0x24/0x25/0x26/0x27/0x0) type:line
[ 6.792648] snd_hda_codec_via hdaudioC0D0: speaker_outs=0 (0x0/0x0/0x0/0x0/0x0)
[ 6.792650] snd_hda_codec_via hdaudioC0D0: hp_outs=1 (0x28/0x0/0x0/0x0/0x0)
[ 6.792652] snd_hda_codec_via hdaudioC0D0: mono: mono_out=0x0
[ 6.792653] snd_hda_codec_via hdaudioC0D0: dig-out=0x2d/0x2e
[ 6.792655] snd_hda_codec_via hdaudioC0D0: inputs:
[ 6.792657] snd_hda_codec_via hdaudioC0D0: Front Mic=0x29
[ 6.792659] snd_hda_codec_via hdaudioC0D0: Rear Mic=0x2b
[ 6.792661] snd_hda_codec_via hdaudioC0D0: Line=0x2a
[ 6.792662] snd_hda_codec_via hdaudioC0D0: CD=0x2c
[ 6.806342] input: HDA Intel MID Front Mic as /devices/pci0000:00/0000:00:1b.0/sound/card0/input14
[ 6.806416] input: HDA Intel MID Rear Mic as /devices/pci0000:00/0000:00:1b.0/sound/card0/input15
[ 6.806480] input: HDA Intel MID Line as /devices/pci0000:00/0000:00:1b.0/sound/card0/input16
[ 6.806547] input: HDA Intel MID Line Out Front as /devices/pci0000:00/0000:00:1b.0/sound/card0/input17
[ 6.806628] input: HDA Intel MID Line Out Surround as /devices/pci0000:00/0000:00:1b.0/sound/card0/input18
[ 6.806696] input: HDA Intel MID Line Out CLFE as /devices/pci0000:00/0000:00:1b.0/sound/card0/input19
[ 6.806763] input: HDA Intel MID Line Out Side as /devices/pci0000:00/0000:00:1b.0/sound/card0/input20
[ 6.806837] input: HDA Intel MID Front Headphone as /devices/pci0000:00/0000:00:1b.0/sound/card0/input21
[ 7.477159] r8169 0000:02:00.0: firmware: failed to load rtl_nic/rtl8168d-2.fw (-2)
[ 7.477164] r8169 0000:02:00.0: Direct firmware load for rtl_nic/rtl8168d-2.fw failed with error -2
[ 7.477167] r8169 0000:02:00.0: Unable to load firmware rtl_nic/rtl8168d-2.fw (-2)
[ 7.478035] RTL8211B Gigabit Ethernet r8169-0-200:00: attached PHY driver [RTL8211B Gigabit Ethernet] (mii_bus:phy_addr=r8169-0-200:00, irq=IGNORE)
[ 7.549511] r8169 0000:02:00.0 enp2s0: Link is Down
[ 9.185382] r8169 0000:02:00.0 enp2s0: Link is Up - 100Mbps/Full - flow control rx/tx
[ 9.185396] IPv6: ADDRCONF(NETDEV_CHANGE): enp2s0: link becomes ready
ps. j'ai finalement bidouillé un câble réseau de 15m provisoirement, donc j'ai une connexion
Dernière modification par Pascalito (26-02-2022 17:01:44)
Debian
Debian-France
Debian-Facile
Debian-fr.org
Forum-Debian.fr
Debian ?
Communautés
